Symbology Selection Enter/Exit Programming Mode
Product Reference Guide 219
Aztec Code Set Length 1
Specifies one of the bar code lengths for Aztec Code Length Control on page
218
. Length 1 is the minimum label length if in Variable Lengt
h
Mode, or the
first fixed length if in Fixed Length Mode. Characters can be set from 0001 to
3,
832 characters in increments of 0001 (pad with zeroes).
See
page 302 for detailed instructions on setting this feature.
Select Aztec Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left follow
ed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
0001 = Length 1 is 1 Character
To Next Page
Loading...
Need help?
General
