Dell Pro Rugged 13 - Installing the Dock I;O-Module

Figure 82. Removing the dock I/O-module
Steps
1. Flip the dock I/O-module and disconnect the dock I/O flexible printed cable from the system board.
2. Lift the dock I/O-module from the system board.
Installing the dock I/O-module
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the dock I/O-module and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
119