Figure 55. Installing the coin-cell battery
Steps
1. Adhere the coin-cell battery to the slot on the computer chassis.
2. Connect the coin-cell battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Install the solid state drive carrier.
3. Install the batteries.
4. Follow the procedure in after working inside your computer.
Fan
Removing the fan
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the batteries.
3. Remove the solid state drive carrier.
4. Remove the base cover.
About this task
The following image indicates the location of the fan and provides a visual representation of the removal procedure.
88
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
