Dell Pro Rugged 13 - Display Back-Cover Assembly; Removing the Display Back-Cover Assembly

Display back-cover assembly
Removing the display back-cover assembly
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the batteries.
3. Remove the solid state drive carrier.
4. Remove the keyboard (rubberized) or keyboard (standard).
5. Remove the base cover.
6. Remove the GPS board.
7. Remove the rear I/O-board.
8. Remove the RF switch board.
9. Remove the WLAN card.
10. Remove the WWAN card.
11. Remove the dock I/O-module.
12. Remove the dock I/O-bracket.
13. Remove the fan.
14. Remove the heat sink ) .
15. Remove the left Type-C board.
16. Remove the system board.
17. Remove the display assembly.
18. Remove the display-panel assembly.
About this task
The following image indicates the location of the display back-cover assembly and provides a visual representation of the
removal procedure.
Removing and installing Field Replaceable Units (FRUs)
157