Figure 103. Removing the left Type-C board
Steps
1. Remove the (M2.3x5) screw that secures the flat printed cable holder to the left Type-C board.
2. Disconnect the flat printed cable from its connector on the left Type-C board.
3. Disconnect the left Type-C cable from its connector on the left Type-C board.
4. Remove the three (M2.3x5) screws that secure the left Type-C board holder to the computer chassis.
5. Remove the (M2x3) screw that secures the left Type-C board to the computer chassis.
6. Slide and remove the left Type-C board from the computer chassis.
Installing the left Type-C board
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the left Type-C board and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
141
To Next Page
Loading...
