Next steps
1. Install the dock I/O-bracket.
2. Install the dock I/O-module.
3. Install the rear I/O-board.
4. Install the WLAN card.
5. Install the RF switch board.
6. Install the base cover.
7. Install the solid state drive carrier.
8. Install the batteries.
9. Follow the procedure in after working inside your computer.
System board
Removing the system board
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the batteries.
3. Remove the keyboard (rubberized) or keyboard (standard).
4. Remove the solid state drive carrier.
5. Remove the base cover.
6. Remove the stylus holder.
7. Remove the GPS board.
8. Remove the rear I/O-board.
9. Remove the RF switch board.
10. Remove the WLAN card.
11. Remove the WWAN card.
12. Remove the dock I/O-module.
13. Remove the dock I/O-bracket.
14. Remove the fan.
15. Remove the heat sink .
16. Remove the left Type-C board.
17. Remove the right Type-C board .
About this task
The following images indicate the connectors on your system board.
126
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
