Table 43. Cable connectors on Dell Pro Rugged 13 RA13250(continued)
Cable number Antenna
10 WLAN antenna
11 GPS antenna
14 GPS antenna
4 GPS antenna
Next steps
1. Install the base cover.
2. Install the solid state drive carrier.
3. Install the batteries.
4. Follow the procedure in after working inside your computer.
Wireless Local Area Network (WLAN) card
Removing the WLAN card
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the batteries.
3. Remove the solid state drive carrier.
4. Remove the base cover.
5. Remove the RF switch board.
About this task
The following image indicates the location of the WLAN card and provides a visual representation of the removal procedure.
Removing and installing Field Replaceable Units (FRUs)
101
To Next Page
Loading...
