Deprag AST40-1 User Manual

50
Lock_Part BOOL
Lock part for F-Function
This signal is currently not available yet!
FC_CycleDone BOOL
Cycle ended for F-Function
This signal is currently not available yet!
Reload BOOL
Reload signal
uni_IO SINT
Output 5 -12 from the screwdriver program
These outputs may be set or reset in the screwdriver
program of the AST40 – controller and its state may be
queried in the PLC.
DATA_AVAILABLE BOOL
Data is available
This signal indicates that new screw data is available.
It is reset by the AST40 – controller if the "DataSaved"
signal is set by the PLC program or a new screwdriver
operation has been started.
HEARTBEAT BOOL
Existence signal of the AST40
This signal is evaluated in the Add-On instruction and in
the event of an error delivers the output ComFault.
MI_Reset_Error BOOL
Error Reset for F-Function (hardware interface)
This signal indicates the status of the Reset signal at the
hardware interface.
(see 6.2.7
I/O interfaces)
MI_Part_Sensor BOOL
Parts sensor for F-function (hardware interface)
This signal indicates the status of the “Parts sensor” signal
at the hardware interface.
(see 6.2.7
I/O interfaces)
MI_Change_Part BOOL
Part release for F-Function (hardware interface)
This signal indicates the status of the “Part release” signal
at the hardware interface.
(see 6.2.7
I/O interfaces)
MI_Ext_Startrelease BOOL
Clearance to start (hardware interface)
This signal indicates the status of the “Start approval”
signal at the hardware interface.
(see 6.2.7
I/O interfaces)
MI_Start BOOL
Start signal (Hardware interface)
This signal indicates the status of the start signal at the
hardware interface.
(see 6.2.7
I/O interfaces)
MI_Reload BOOL
Reload signal (hardware interface)
This signal indicates the status of the reload signal at the
hardware interface.
(see 6.2.7
I/O interfaces)
MI_IN_SchrPrg1 BOOL
Input 1 for the screwdriver program (Hardware
interface)
This signal indicates the status of input 1 at the hardware
interface.
(see 6.2.7
I/O interfaces)
MI_IN_SchrPrg2 BOOL
Input 2 for the screwdriver program (Hardware
interface)
This signal indicates the status of input 2 at the hardware
interface.
(see 6.2.7
I/O interfaces)

Deprag AST40-1 Specifications

General

Brand	Deprag
Model	AST40-1
Category	Controller
Language	English