To Next Page

To Previous Page

interface)

This signal indicates the status of input 4 at the hardware

interface.

(see 6.2.7

I/O interfaces)

SysStatus INT

System status

This parameter indicates the system status of the AST40 –

screwdriving controller.

(for possible status values, see 15.1

System error)

ErrorCode WORD

Error Code

This parameter indicates the internal errors in the module.

(for possible errors, see below)

Table 12: Data structure of the status signals (UDT22)

7.6.1.3.4 Description of the – Error Code:

Error Description

FF00

Error in the input address range

Cause:

The transfer parameter I_AddrX (X=1-4) is not assigned or there is a value of smaller

or equal to 0.

FF01

Error while reading the input module 1 (I_Addr1)

Possible causes:

 An incorrect input module has been entered in the hardware configuration. Input

module 1 must be configured with "64 bytes in".

 Incorrect start address of the input module 1 at the interface parameter I_Addr1

FF02

Error while reading the input module 2 (I_Addr2)

Possible causes:

 An incorrect input module has been entered in the hardware configuration. Input

module 2 must be configured with "64 bytes in".

 Incorrect start address of the input module 2 at the interface parameter I_Addr2

FF03

Error while reading the input module 3 (I_Addr3)

Possible causes:

 An incorrect input module has been entered in the hardware configuration. Input

module 3 must be configured with "64 bytes in".

 Incorrect start address of the input module 3 at the interface parameter I_Addr3

FF04

Error while reading the input module 4 (I_Addr4)

Possible causes:

 An incorrect input module has been entered in the hardware configuration. Input

module 4 must be configured with "32 bytes in".

 Incorrect start address of the input module 4 at the interface parameter I_Addr4

FF10

Error in the output address range

Cause:

The transfer parameter I_AddrX (X=1-4) is not assigned or there is a value of smaller

or equal to 0.

FF11

Error while writing to the output module 1 (O_Addr1)

Possible causes:

 An incorrect output module has been entered in the hardware configuration.

Output module 1 must be configured with "64 bytes out".

 Incorrect start address of the output module 1 at the interface parameter

O_Addr1

FF12

Error while writing to the output module 2 (O_Addr2)

Possible causes:

Brand	Deprag
Model	AST40-1
Category	Controller
Language	English

Deprag AST40-1 User Manual

Table of Contents

Questions and Answers:

Deprag AST40-1 Specifications

Related product manuals