67
Figure 44: System setup – Date / Time
Press the key , to get to the next settings page or , to go the previous settings page.
The general settings are located on the fourth page of the System Setups. Select the unit
of measure for the torque by pressing on the required unit.
Adjust the main direction of rotation.
Select whether the reduction in the rotational speed should be active or inactive.
Figure 45: System setup – General, Page 1
Press the key , to get to the next settings page or , to go the previous settings page.
Additional general settings are located on the fifth page of the System Setups. Enter, when
a signal tone should be emitted.
To Next Page
Loading...
Need help?
General
