Deprag AST40-1 User Manual

73
Figure 58: Adjustment of the touch display
9.2.6 Menu Area – Screwdriving Sequence
Figure 59: Menu Area – Screwdriving Sequence
9.2.6.1 Screwdriving Sequence
Standard programs can be created and parameters of existing programs can be modified
in the menu Screwdriving Sequence. If you wish to add additional steps or options, e.g.
activate angle monitoring then this must be done via the web user interface (also see
10.3.4 Menu Area – Screwdriving sequence).
The prerequisite for this is that a user is logged in. If no user is logged in, only the set
values are displayed. No modifications or no standard programs can then be created.
IMPORTANT
A backup of the screwdriving sequences can only be created via the web
user interface (siehe 10.3.4.2 Create / Load Backup).
First, choose the number of the program for which you want to display the parameters or
create a standard program. To do this, directly enter the program number or use the keys
and .

Deprag AST40-1 Specifications

General

Brand	Deprag
Model	AST40-1
Category	Controller
Language	English