Setting the Connection with the Computer
107
4. Useful Functions
5.
Return the computer's network environment to its original values.
* This step is not necessary if the computer and the machine are directly connected during use�
A
Disconnect the LAN cable that connects the computer and the machine.
B
Return the computer's network environment to the state recorded in step 1..
C
Connect the machine and the computer using the appropriate network.
Consult your network administrator before connecting the machine and the computer using the workplace network.
D
Check the following items for the machine connected with a LAN cable.
• The operating status is [READY].
• The set IP address is displayed.
• The machine's status light ashes when you click the machine's image.
Checking the above items completes the connection procedure.
MEMO
• The machine is added to [Devices and Printers] in Control Panel�
• If you want to change the network settings of the milling machine, click [IP Settings] on the [Settings] tab in the [Settings]
window in VPanel�
To Next Page
Loading...
