Starting Milling
35
2. Milling
H
Remove the product.
CAUTION
Be careful around milling waste.
Sharp milling waste may become mixed. To avoid injury, exercise caution.
CAUTION
Do not touch the spindle unit or the surrounding areas immediately after milling has ended.
Doing so may result in burns.
CAUTION
After milling, wash away any products with puried water or the like.
After milling, there will be coolant on the product. Using the product as is may cause an inammation
or the like.
MEMO
Press the operation button during standby to rotate the rotary axis 180 degrees� This function is useful when you want to view
the back of the product without removing the workpiece�
Operation button
To Next Page
Loading...
