Following Daily Operations
49
2. Milling
C
Visually check that coolant is applied to the middle of the dummy pin.
If coolant is not applied to the middle of the dummy pin
1 Click [No].
The following window is displayed.
2 Click [OK], and then check the following items.
• Coolant amount
" P. 22 "Step 1: Filling the Machine with Coolant".
• Coolant nozzle clogging
" P. 70 "Cleaning the Coolant Nozzle".
• Coolant lter clogging
" P. 72 "Replacing Coolant Filters".
3 Once more, visually check that coolant is applied to the middle of the dummy pin.
Proceed to step 4.
If coolant is applied to the middle of the dummy pin
Click [Yes].
This completes the collet maintenance.
4.
Check the coolant ow rate again.
A
Show VPanel.
" P. 6 "Displaying VPanel"
B
Select the machine to operate.
To Next Page
Loading...
