Manuale operativo
CHORUS
104 Rev. 0 del 06/2012
5.4.2 E
RRORS IN FUNCTIONING
5.4.2.1 Warnings
1 Printer paper empty
Description: the paper is lacking in the printer
Corrective action: replace the roll of paper
2 Lever printer lifted
Description: the printer carriage is open
Corrective action: lower the lever of the paper carriage
3 Lid unchecked
Description: the lid check was skipped
Corrective action: open/close the door when requested
4 Ext. Barcode-reader
Description: external barcode reader not connected or damaged
Corrective action: control the connection of the barcode reader
5 Micro-modem fault
Description: The micro-modem board is not connected or is damaged
Note: The error is only active when the remote functioning is enabled.
6 Modem timeout
Description: the modem does not respond because not connected or is damaged
Note: The error is only active when the remote functioning is enabled.
7 Modem fault
Description: the modem responds with an error message
8 Strip thermometer
Description: the strip thermometer does not respond
9 Strip temp. adj.
Description: Strip thermostat out of range
10 Instrument thermometer
Description: the instrument thermometer does not respond
11 Instr. Temp adj.
Description: Instrument thermostat out of range
The four temperature errors (8-11) are declassed to warnings only during the cycle, to allow the
instrument to process all the strips in any instance, and the operator makes the final decision as to
whether or not to accept the results.
In the printed report, the strips processed with a temperature error will be identified by a “T”.
To Next Page
Loading...
