Digi XBee 3 ZigBee User Manual

Frame descriptions Extended Modem Status frame - 0x98 Digi XBee® 3 Zigbee® RF Module 309
Status
code
Transparent
mode string Description Status data Description
0x0F Join Request High level request for a form/join.
0x10 Reject LQI Reject because LQI is worse than an already
saved beacon
lqi(1) link quality indicator
0x11 Reject RSSI Rejected because RSSI is worse than an
already saved beacon
rssi(1) relative signal strength indicator
0x12 Rejected
(cmdL ast)
Rejected because it matches the last
associated network.
0x13 Rejected
(cmdS ave)
Rejected because it matches an already saved
beacon response.
0x14 Reject
strength
During first/best phase, response is weaker
than an already saved beacon response.
0x16 Reset for
DC80
With DC80 enabled, reset if no joinable beacon
responses are received within 60s of joining.
0x18 ScanCh Scanning on Channel radioChannel
(1)
channel number ranging from 11 to 26 (0x0B to 0x1A)
0x19 Scan Mode Shows phase of Ordered Association. mode(1)
0: first/bestcandidate
1: ordered association by extpanid, then by channel
0x1A Scan Init Starting a scan channel(1)
TxPower(1)
channel being scanned
low level radio transmit power setting
0x1D Energy Scan -
channel mask
Starting energy scan
SC mask(4)
Scan channel mask
0x1E Energy Scan -
energies
Channel Energies observed Energies(16)
Energy Levels per channel in SC
0x1F PanIdScan -
radio channel
Pan Id Scan starting on channel channel(1) Radio Channel

Digi XBee 3 ZigBee Specifications

General

Brand	Digi
Model	XBee 3 ZigBee
Category	Control Unit
Language	English