To Next Page

To Previous Page

Storing/Copying a Preset

Storing a Preset

Once you have modified the Amp Models, Cabinet Types, and Effect Parameters, the

Store button LED flashes indicating you have changed a parameter and need to store

the changes to a User Preset location in order to recall them later. The following steps

outline the procedure for storing a preset:

1. Press the STORE button. The first letter of the preset name begins flashing.

2. Use the DATA WHEEL to select the alpha-numeric character.

3. Press the NEXT button to select the next character to the right, and the

button to select the previous character to the left.

Name

2. Use the Data Wheel to select

an alpha-numeric character

1. Press Store

3. Use the Next button to

select the next character

4. Repeat steps 2 and 3 until you are finished naming the new preset.

5. Press the STORE button again. The current preset location will then flash in the

red display.

6. Select the User Preset location using the DATA WHEEL.

7. Press the STORE button again to finish.

number

5. Press Store again

6. Select a User

preset using the

Data Wheel

7. Press Store again

GNX3000 Owner’s Manual

Storing/Copying a Preset

DigiTech GNX3000 User Manual

Other manuals for DigiTech GNX3000