GNX3000 Owner’s Manual
35
GNX3000 Owner’s Manual
reads: Lrn LICK
4. Release the pause button on your playback device and press FOOTSWITCH 3.
The display reads:
RECORD. The red numeric display provides a time elapsed
reference while recording is in process. When recording is complete, the
recorded passage is set in an auto-loop playback, indicated by play appearing in
the display.
5. Press Stop or Pause on the playback device.
6. Use the DOWN FOOTSWITCH to slow the playback down, or use the
UP
FOOTSWITCH to increase the playback speed at 1/8 speed intervals.Your
interval choices include:
FULL, 7/8, 3/4, 5/8, 1/2, 3/8, and 1/4 speeds.
7. Press FOOTSWITCH 2 to step back through the loop at 1 second intervals.
8. The EXPRESSION PEDAL controls the output level of the recorded phrase.
9. To stop the playback, press FOOTSWITCH 1
.
10. To resume playback, press FOOTSWITCH 4
.
11. To record a new passage, press FOOTSWITCH 3
.
12. To exit Learn-A-Lick
TM
, press and hold FOOTSWITCHES 1 and 2, or press
EXIT in the control panel.
Bypass
The GNX3000 presets can be bypassed for a clean, unprocessed guitar signal. Bypass
turns off all effects and modeling. To bypass the GNX3000 in Preset Mode, press the
active preset’s Footswitch (the 1-5 footswitch that is lit). To bypass the GNX3000 while
in Stompbox or Record/Drum Mode, press FOOTSWITCHES 2 and 3 simultaneously.
When the GNX3000 is bypassed, the display reads
BYPASS and all LEDs in the
Matrix turn off. Press any Footswitch to exit Bypass and return to the last preset. The
Matrix and Programming buttons do not function when Bypass is activated.
NOTE: If Preset Bounceback is enabled in the Utility menu, pressing the active
preset’s footswitch while in Preset Mode will not bypass the GNX3000’s effects. To
bypass the GNX3000’s presets while Preset Bounceback is enabled you must press
FOOTSWITCHES 2
and 3 simultaneously.
Tuner
The Tuner in the GNX3000 lets you quickly tune or check the tuning on your guitar.
Press FOOTSWITCHES 3 and 4 simultaneously to access the TUNER. The display briefly
flashes tuner. To begin tuning, play a note on your guitar (a harmonic at the 12th
fret also works). The red numeric display shows the note being played, and the green
alpha-numeric display indicates whether the note is sharp or flat. Arrows to the left
(<<<) indicate the note is sharp and should be tuned down. Arrows to the right (>>>)
indicate the note is flat and should be tuned up. When your note is in tune,
-><- is displayed.
GNX3000 Owner’s Manual
35
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
