DigiTech GNX3000 User Manual

5. Now we need to choose one of the 9 User HyperModel locations. Use the
DATA WHEEL to select a an empty user location. The display should read
EMPTY (Empty) and the red numeric display should read U1 if this is the first
HyperModel stored to your GNX3000.
6. Press the AMP SAVE button again to save to this Amp location. The display
briefly reads
AMP SaVeD (Amp Saved) and then returns to the name of the
selected preset.
5. Use the Data Wheel
to select an empty
User Amp location
empty
6. Press the Amp
Save button
u1
Select Models for the Preset’s Channels
In the previous steps, we selected a Tweed amp model for the Channel 1 amp and a
Rectified amp model for the Channel 2 amp. Then we warped the two together to
create our HyperModel
TM
. This HyperModel is saved as an amp type that we named
Rectwed, but it is not currently part of our preset. In this example preset, we need to
be able to toggle between an acoustic guitar simulation and our new HyperModel. To
do this we need to now select the Dreadnaught acoustic guitar model for Channel 1’s
amp and our custom Rectwed for Channel 2’s amp in our preset. This procedure is as
follows:
1. Press the
GENETX Amp Control button.
2. Rotate KNOB 1 until the display reads
AC dread. This is Channel 1’s Model
for the preset.
3. Rotate KNOB 4 until the display reads
RECTWeD (our new HyperModel).
This is Channel 2’s Model for the preset. This lets us toggle between these two
sounds using the Amp Footswitch (when Preset Mode is active).
2. Rotate the Knob 1
until Display reads
ac dread
3. Rotate Knob 4
until Display reads
rectwed
1. Press the GENETX
Amp Control button
86
GNX3000 Owner’s Manual
Creating a Preset

DigiTech GNX3000 Specifications

General

Brand	DigiTech
Model	GNX3000
Category	Music Pedal
Language	English