Detune
A Detuner makes a copy of your incoming signal, takes the copied signal slightly out
of tune from the original, and mixes the two signals together. The result is a doubling
type of effect as if two guitars were playing the same part together.
Parameter 1
KNOB 2 selects the Amount (AMouNT) of detuning applied to the copied pitch in
cents (100 cents equals 1 semitone). Ranges are from 24 cents below
(-24) to 24
cents above
(24).
Knob 3
No function when Detune is selected.
Knob 4
No function when Detune is selected.
Level
KNOB 5 adjusts the Detune Level (
dtn LeVL) of all pitch-altering effects in this
module. Ranges from 0 to
99.
Pitch Shift
A Pitch Shifter copies the incoming signal, then shifts the pitch of the copied note to a
different note. The shifted note is then mixed back with the original signal sounding as
if two guitars were playing parallel notes.
Parameter 1
KNOB 2 selects the Shift (SHIFT) of the pitch in semitone intervals. Ranges from
two octaves below
(-24) to two octaves above (24).
Knob 3
No function when Pitch Shift is selected.
Knob 4
No function when Pitch Shift is selected.
Level
KNOB 5 adjusts the Pitch Level (pch LeVL) of all pitch-altering effects in this
module. Ranges from 0 to
99.
56
GNX3000 Owner’s Manual
Effects and Parameters
To Next Page
Loading...
Need help?
General
