GNX3000 Owner’s Manual
33
GNX3000 Owner’s Manual
Applying Power
Before applying power to anything, set your amp(s) to a clean tone and set the
tone controls to a flat EQ response (on most amps, this would be 0 or 5 on the tone
controls). Then do the following:
1. Turn your amp’s volume all the way down.
2. Pull the mixer’s master faders all the way down.
3. Turn the GNX3000’s OUTPUT LEVEL KNOBS all the way down (fully counter-
clockwise)
.
4. Connect the plug of the PSS3 power supply to the GNX3000’s POWER JACK.
Connect the other end of the PSS3 power supply to an AC outlet.
5. Turn the GNX3000’s power on.
6. Turn your amplifier
(s) on and adjust the volume(s) to a normal playing level.
7. Push the mixer’s master faders up to the desired listening level.
8. Gradually increase the GNX3000’s Output Levels to the desired listening level.
GNX3000 Owner’s Manual
33
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
