Select and Adjust the Reverb
In our example preset we wanted a little bit of Hall Reverb to provide some
ambience. To add the reverb, do the following:
1. Press the EFFECT SELECT DOWN button until the LED in the Reverb row lights.
2. If the display reads off (
Of), press the STATUS button until the display reads on
(On).
3. Rotate KNOB 1 to select Hall (
Hall) for the Reverb Type.
4. Rotate KNOB 2 to set the Reverb Predelay to
2.
5. Rotate KNOB 3 to set the Reverb Decay to
15.
6. Rotate KNOB 4 to set the Reverb Damping to
40.
7. Rotate KNOB 5 to set the Reverb Level to
30.
hall
1. Press Effect Select
Down again until the
Reverb LED lights
3. Rotate Knob 1
to select Hall as
the Reverb type
2. Press the Status button to
turn on the Reverb
4. Rotate Knob 2
to set the Reverb
PreDelay to 2
5. Rotate Knob 3
to set the Reverb
Decay to 15
6. Rotate Knob 4
to set the Reve
rb
Damping to 40
7. Rotate Knob 5
to set the Reverb
Level to 30
90
GNX3000 Owner’s Manual
Creating a Preset
To Next Page
Loading...
Need help?
General
