GENETX
TM
Row
STATUS
BUTTON
KNOB
1
KNOB
5
KNOB
4
KNOB
3
KNOB
2
GENETX ROW
The GENETX row is where amp and cabinet models are selected for the current preset.
It is also where the Warp function resides allowing GeNetX
TM
warping between the
two amp models. When the
GENETX row is selected, the Knobs and STATUS button
perform the following functions:
Status button
Selects between Amp Channel 1 (Green) and Amp Channel 2 (Red) and lets
you hear each channel independently. If a Warped state (Yellow) between both
channels exists, this button also selects it and lets you hear the warped amp.
The STATUS
button’s LED will light Green, Red, or Yellow depending on which
channel is selected.
Knob 1
Selects the Channel 1 (Green) amp model and its LED is lit green.
Knob 2
Selects the Channel 1 (Green) cabinet model and its LED is lit green.
Knob 3
Warps the Channel 1 and Channel 2 amp and cabinet models together. Setting
this parameter to its minimum position selects Channel 1’s amp and cabinet only
and its LED is lit green. Setting this parameter to its maximum position selects
Channel 2’s amp and cabinet only and its LED is lit red. Setting KNOB 3 to any
other position selects a warped state, a combination of Channel 1 and 2’s amp and
cabinet models and the LED will be lit yellow.
Knob 4
Selects the Channel 2 (Red) amp model and its LED is lit red.
Knob 5
Selects the Channel 2 (Red) cabinet model and its LED is lit red.
40
GNX3000 Owner’s Manual
GNX3000 Matrix Functions
To Next Page
Need help?
General
