Turn the Compressor Off
We don’t use compression in our preset so, we need to turn the Compressor off.
To turn the Compressor off, do the following:
1. Press the EFFECT SELECT DOWN button. The Compression LED lights and the
display shows the current status of the Compressor.
2. If the Compressor is on, press the STATUS
button until the red display reads off
(Of).
Turn the Whammy
TM
/IPS/Talker
TM
Off
We don’t want Whammy, IPS, or Talker effects in this preset. To turn these effects
off, do the following:
1. Press the EFFECT SELECT DOWN button, and the Whammy/IPS/Talker LED is
lit.
2. If the display indicates that one of these effects is active, press the STATUS
button until the display reads off (Of).
Turn the Stompbox Modeling Off
To turn the Stompbox Modeling off for this preset, do the following
1. Press the EFFECT SELECT DOWN button until the Stompbox LED is lit.
2. If the display indicates that it is active, press the STATUS
button until the
display reads off (
Of).
Adjust the Noise Gate
For our example, we want our Noise Gate to open quickly with a relatively weak
signal. This type of gate uses the Silencer
TM
with a low threshold and short attack
time. To create this type of Noise Gate, do the following:
1. Press the AMP FOOTSWITCH to select the Channel 2 Amp (
CH2 AMP), our
high gain model.
2. Press the EFFECT SELECT DOWN button and the Noise Gate’s LED lights.
3. If the display reads off (
Of), press the STATUS button until the display reads on
(On).
4. Rotate KNOB 1 until the display reads
SILeNCeR for the type of gate.
5. Rotate KNOB 2 to set the Threshold to
37 (this may need to be adjusted
depending upon your guitar).
6. Rotate KNOB 3 to set the Attack Time to
0 (fast attack).
88
GNX3000 Owner’s Manual
Creating a Preset
To Next Page
Need help?
General
