Quick Start
Make Connections
1. Connect your instrument to the GUITAR/INSTRUMENT INPUT on the
GNX3000’s rear panel.
2. Connect either the 1/4” or XLR LEFT/RIGHT OUTPUTS to the input(s) of your
amplifier(s), power amp, or mixer.
Apply Power
1. Turn the OUTPUT LEVEL knobs (for both the 1/4” and XLR OUTPUTS), on the
rear panel of the GNX3000, all the way down (fully counter clockwise).
2. Connect the PSS3 power supply to the Power jack on the GNX3000.
3. Connect the other end of the PSS3 power supply to an AC outlet.
4. Turn the GNX3000 POWER SWITCH on.
5. Turn your amplifier(s) on, and adjust the volume(s) to a normal playing level.
Gradually turn up the GNX3000’s output level until you reach your desired
listening level.
Setups
Here are three of the most popular setups, and one of them is probably what you’re
looking for. For additional setups see page 27.
Single Amp
For a simple guitar-to-workstation-to-amp setup, just plug your guitar into the
GUITAR INPUT (on the back panel) and plug the LEFT 1/4” BALANCED OUTPUT
into your amp. Turn Speaker Compensation off for the 1/4” OUTPUTS
(see page
24).
Guitar Input Left 1/4" Balanced Output
Amplifier
GNX3000 Owner’s Manual
3
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
