Talker
TM
The Talker is an effect that lets your instrument’s signal be manipulated by your voice.
The Talker requires a microphone be connected to the MIC INPUT on the rear panel of
the GNX3000. As you speak into the microphone, your instrument mimics what you say.
There are five Talker types.
Type
KNOB 1 is used to select one of the 5 Talker types. Talker Types range from talker
1 (deep tonal characteristics), to talker 5 (bright tonal characteristics).
Parameter 1
KNOB 2 adjusts the Sensitivity of the microphone level (MIC LEVL). The input
level from your microphone must be loud enough for the Talker to work properly. If
the microphone input is too weak, the Talker will have trouble tracking. If the input
is too strong, the Talker will clip making the words unintelligible. Adjust the mic
level on the GNX3000’s rear panel so that the LEDs light, but stay below the clip
level. (See Mic Level Optimization on page 26 for more information regarding mic
level adjustment.) The mic level sensitivity ranges are from
0 (least sensitive) to 99
(most sensitive).
Knob 3
No function when Talker is selected.
Knob 4
No function when Talker is selected.
Knob 5
No function when Talker is selected.
GNX3000 Owner’s Manual
57
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
