DigiTech GNX3000 User Manual

1. Connect a MIDI cable from the GNX3000 MIDI Out to the MIDI In of a MIDI
recording device.
2. Press the
UTILITY button. The Utility button’s LED will light.
3. Use the
PREV or NEXT buttons to select PrSTDuMP (Preset Dump).
4. Use the DATA WHEEL to select the preset number you want to dump.
5. Press the STORE button. The Display will read
SeND TO.
6. Press the STORE button again. The display will read
send pst until the dump
is complete at which time the display returns to
PrSTDuMP.
7. When finished, press EXIT
.
NOTE: MIDI Preset Dump sends information on the MIDI channel defined in the
MIDI Channel Menu.
User HyperModel
TM
Amp Dump
This operation performs a System Exclusive (SysEx) User Hypermodel
TM
Amp
Dump that uploads the GNX3000 Amp HyperModels to a SysEx librarian or MIDI
recording device. This is useful for making a backup copy of your customized Amp
HyperModels. The procedure for performing a User Amp Dump is as follows:
1. Connect a USB cable to your computer or a MIDI cable from the GNX3000
MIDI Out to the MIDI In of a MIDI recording device.
2. Press the
UTILITY button. The Utility button’s LED will light.
3. Use the PREV
or NEXT buttons to select AMP DuMP (Amp Dump).
4. Use the DATA WHEEL to select the Amp number you want to dump.
5. Press the STORE button. The display will read
SND TO.
6. Set the MIDI recording device to record.
7. Press the STORE button again. The display will read
send amp until the dump
is complete at which time the display returns to
AMP DuMP.
8. When finished, press EXIT
.
NOTE: Amp Dump sends information on the MIDI channel defined in the MIDI
Channel Menu.
MIDI Mapping
MIDI Mapping provides access to all factory and user presets from external MIDI
program change commands that may not correspond to the GNX3000 preset. This
is useful when multiple MIDI devices are chained together and controlled by one
central unit. For example, the main MIDI controller can send out a program change
command telling a particular MIDI unit to change to Program 10, but you may want
the GNX3000 to change to User Preset 27. You can remap the GNX3000 so when
it receives MIDI Program change 10, it calls up User Preset 27. The Procedure for
mapping MIDI program changes is as follows:
GNX3000 Owner’s Manual
121
GNX3000 Owner’s Manual

DigiTech GNX3000 Specifications

General

Brand	DigiTech
Model	GNX3000
Category	Music Pedal
Language	English