Adjust Channel 2 Tone Controls
Like the Tweed amp in Channel 1, the Rectified amp in Channel 2 may need to be
adjusted to suit your personal taste. To access the tone controls for Channel 2, do
the following:
1. Press the STATUS
button until the display reads ch2 amp and all the
horizontal LEDs will light red indicating that all 5 knobs will adjust Channel 2’s
tone controls.
2. Rotate KNOB 1 to adjust the Rectified Amp’s Gain. The range is from
0 to 99.
3. Rotate KNOB 2 to adjust the Rectified Amp’s Bass EQ Level (boost/cut). The
range is from -12 dB
(-12) to +12 dB (12).
4. Rotate KNOB 3 to adjust the Rectified Amp’s Midrange EQ Level (boost/cut).
The range is from -12 dB
(-12) to +12 dB (12).
5. Rotate KNOB 4 to adjust the Rectified Amp’s Treble EQ Level (boost/cut). The
range is from -12 dB
(-12) to +12 dB (12).
6. Rotate KNOB 5 to adjust the Rectified Amp’s Level. The range is from
0 to 99.
2.-6. Rotate Parameter knobs to
adjust Channel 2’
s Gain, EQ levels,
and Amp levels.
1. Press the Status button to
turn the EQ on and off
GNX3000 Owner’s Manual
83
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
