Chorus
A Chorus adds a short delay to your signal. The delayed signal is modulated in and out
of tune and then mixed back with the original signal to create a thicker sound.
Parameter 1
KNOB 2 adjusts the rate (Speed) of the modulation. Ranges from 0 to 99.
Parameter 2
KNOB 3 adjusts the intensity (Depth) of the modulation. Ranges from 0 to 99.
Parameter 3
KNOB 4 adjusts the PreDelay (PREDeLaY) or length of time before the Chorus
effect is applied to the input signal. Ranges from
1 to 20.
*Parameter 4
Selects the waveform used by the Chorus. Waveforms include: Triangle,
Sine, and Square.
*Parameter 5
Adjusts the left to right balance of the wet signal, Ranges from mod left 99
to mod rght 99.
Mod Level
KNOB 5 controls the level (mod levl) of the Chorus. Ranges from 0 to 99.
*These Parameters are only available using the X-Edit
TM
Editor/Librarian software.
62
GNX3000 Owner’s Manual
Effects and Parameters
To Next Page
Loading...
