in the Control Panel and the DATA WHEEL. Up to four channels of audio can be
recorded on the computer via USB. Each Input Source routes a pair of signals
(except MONO FX, MONO ALL, DRY GUITAR, DRY MIC, and DRUMS MN
which are mono signals) to the computer. The Input Sources signal combinations
are as follows:
USB 1-2 Source
stereofx
All input sources that are routed through the GNX3000’s effects are sent as a
stereo pair up USB 1 and 2 channels. Drums, Dry Mic, and Dry Line are not
recorded.
steroall
All input sources that are routed through the GNX3000’s effects, Drums, Dry
Mic, and Dry Line are sent as a stereo pair up USB 1 and 2 Channels.
mono fx
All input sources that are routed through the GNX3000’s effects are summed
to mono and sent up the USB 1 channel. Nothing is sent up USB 2 Channel.
Drums, Dry Mic, and Dry Line are not recorded.
mono all
All input sources that are routed through the GNX3000’s effects, Drums, Dry
Mic, and Dry Line are summed to mono and sent up the USB 1 Channel.
Nothing is sent up USB 2 channel.
sum+dGTR
All input sources that are routed through the GNX3000’s effects are summed
to mono and sent up the USB 1 channel. Dry guitar is sent up the USB 2
channel.
sum+mic
All input sources that are routed through the GNX3000’s effects are summed
to mono and sent up the USB 1 channel. Dry mic signal is sent up the USB 2
channel.
dgtr+mic
Dry guitar signal is sent up the USB 1 channel. Dry mic is sent up the USB 2
channel.
dry line
Dry Line Left Input signal is sent up the USB 1 channel. Dry Line Right
Input is sent up the USB 2 channel.
GNX3000 Owner’s Manual
103
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
