Flanger
A Flanger uses the same principle as a Chorus but has a shorter delay time and adds
regeneration (or repeats) to the modulating delay. This results in an exaggerated up
and down sweeping motion to the effect.
Parameter 1
KNOB 2 adjusts the rate (Speed) of the modulation. Ranges from 0 to 99.
Parameter 2
KNOB 3 adjusts the intensity (Depth) of the Modulation. Ranges from 0 to 99.
Parameter 3
KNOB 4 adjusts the amount of feedback (Regen) added to the Flanger delay.
Ranges from 0 to
99.
*Parameter 4
Selects the waveform used by the Chorus. Waveforms include: Triangle,
Sine, and Square.
*Parameter 5
Adjusts the left to right balance of the wet signal, Ranges from mod left 99
to mod rght 99.
Mod Mix
KNOB 5 controls the mix (mod mix) of wet and dry signal. Ranges from 0 (all
dry) to 99 (all wet).
GNX3000 Owner’s Manual
63
GNX3000 Owner’s Manual
*These Parameters are only available using the X-Edit
TM
Editor/Librarian software.
To Next Page
Loading...
