LFO Links 1-2
Each preset has two LFOs that can each be assigned to a single parameter. Each LFO
has the following assignment options:
1. Parameter Type (see attached parameter list)
2. Min Value
3. Max Value
4. LFO Waveform
5. LFO Speed
The procedure for assigning a parameter to the LFO 1 or LFO 2 is as follows:
1. Press either EFFECT SELECT button until the EXPRESSION ASSIGN row is selected.
2. Press the STATUS
button to assign LFO1 (LFO 1) or LFO2 (LFO 2).
3. Rotate KNOB 1 until the Parameter is displayed. See the Expression Parameter
Assignment List on page
77
for a complete list of assignable Parameters.
4. Rotate KNOB 2 to select the minimum value the assigned parameter reaches at
the bottom turn around point for the LFO.
5. Rotate KNOB 3 to select the maximum value the assigned parameter reaches at
the top turn around point for the LFO.
6. Rotate KNOB 4 to select the speed that the LFO oscillates from the minimum to
the maximum values. LFO speed ranges from (
.O5 Hz) to 10 Hz (1o HZ).
7. Rotate KNOB 5 to select the waveform the LFO oscillates on. Your choices
include:
Triangle - a smooth rise and fall, but abrupt turn around in oscillation.
SINE - a smooth rise, fall, and turn around in oscillation.
SQUARE - an abrupt rise, fall, and turn around in oscillation.
8. Store your LFO assignment to your preset. See page 92 for more information
on the storing procedure.
Expression Parameter Assignment List
The following parameters can be assigned to the EXPRESSION PEDAL Links or LFO 1
and LFO 2.
NO LINK (No Link) No Parameter is assigned
AMP CHaN (Amp Channel) Switches Amp Channels
Amp WARP (Amp Warp) Warps the Channel 1 and Channel 2
Amp Models
Cab WARP (Cabinet Warp) Warps the Channel 1 and Channel 2
Cabinet types
WARP (Warp) Warps Channel 1 and Channel 2
Amp and Cabinet Models
simultaneously
ch1 GAIN (Channel 1 Gain) Controls the Gain for Channel 1
Amp Model
GNX3000 Owner’s Manual
77
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
