Phaser
A Phaser splits the incoming signal, takes the split signal in and out of phase and
mixes it back in with the original signal. As the phasing changes, different frequencies
are canceled resulting in a warm sort of twisting sound.
Parameter 1
KNOB 2 adjusts the rate (Speed) of the modulating phase. Ranges from 0 to 99.
Parameter 2
KNOB 3 adjusts the intensity (Depth) of the modulation. Ranges from 0 to 99.
Parameter 3
KNOB 4 adjusts the amount of effected signal returned to the input of the Phaser
(Regen). Ranges from 0 to 99.
*Parameter 4
Selects the waveform used by the Phaser. Waveforms include: Triangle,
Sine, and Square.
*Parameter 5
Adjusts the left to right balance of the wet signal, Ranges from mod left 99
to mod rght 99.
Mod Level
KNOB 5 controls the level (mod levl) of wet and dry signal. Ranges from 0 (all
dry) to 99 (all wet).
64
GNX3000 Owner’s Manual
Effects and Parameters
*These Parameters are only available using the X-Edit
TM
Editor/Librarian software.
To Next Page
Loading...
Need help?
General
