USB 1-2 Level/USB 3-4 Level
The USB 1-2 LVL and USB 3-4 LVL knobs are used for boosting or cutting the amount
of signal sent out the USB port to the computer. These controls are to be used if
the signal level of the input source (mic, line input, guitar) isn’t optimized into your
recording software (consult the Pro Tracks Plus User’s Guide for information on
proper recording levels). If the signal is too hot to Pro Tracks Plus, use these controls
to decrease the level. The USB 1-2 LVL and USB 3-4 LVL parameters control the level for
each USB pair of outputs so for example, if
sum+mic is the selected USB 1-2 Source,
increasing the level for the mic 6dB going up USB 2 will also increase the summed
signal by 6dB going up USB 1. To increase or decrease the level of audio going up to
the computer, follow these steps.
1. Play/sing through the GNX3000 and check the level of signal reaching the
recording software (consult the Pro Tracks Plus
TM
User’s Guide for information
on how to view recording signal levels).
2. Use whichever USB Level knob to boost or cut the signal level going to the
recording software. The boost/cut range is from -12dB (
usb 1-2 -12) to
+24dB (
usb 1-2 24). The DATA WHEEL may also be used to change the
selected USB level.
GNX3000 Owner’s Manual
117
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
