To select an Amp and Cabinet model:
1. Push the GENETX BUTTON
.
2. Turn KNOB 1 or KNOB 4 to select an amp model.
3. Turn
KNOB 2 or KNOB 5 to select a cabinet model.
See page 44 for more information about Amp/Cabinet modeling.
Recording - Computer
If you’re ready to start recording, here’s how to connect the GNX3000 to your
computer. You’ll also need to install the included software; see page
101
for more
information.
Guitar
Input
Line Inputs
XLR
Balanced
Outputs
MIDI Keyboard
MIDI
Audio
Microphone
Headphones
Powered Studio Monitor
Powered Studio Monitor
USB Cable
Computer
GNXFC Foot Controller
(Optional)
Mic Input
1. Connect your guitar (or bass guitar) to the GNX3000’s GUITAR INPUT.
2. Connect a microphone to the GNX3000’s MIC INPUT and use the MIC LEVEL
control knob located next to the MIC INPUT on the GNX3000’s rear panel to
adjust the microphone output level. To adjust your microphone input level for
optimal use see Mic Level Optimization on page 26.
3. Connect a keyboard, line level instrument, or stereo mixer (for feeding
submixes) to the GNX3000’s LEFT
and RIGHT LINE INPUTS. To adjust your line
input levels for optimal use see Line Level Optimization on page 26.
4. Connect XLR cables from the GNX3000’s LEFT
and RIGHT XLR OUTPUTS
to powered studio monitors, OR connect a pair of stereo headphones to the
HEADPHONE OUTPUT
.
5. Connect a GNXFC Foot Controller (optional) to the GNX3000’s FOOTSWITCH
JACK
.
6
Quick Start
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
