USB 3-4 SOURCE
Selects what Input Sources are to be recorded up the USB 3-4 channels.
MIC
Selects how the mic input is routed through the GNX3000’s effects processing for
both recording an performance.
LINE
Selects how both LINE INPUTS are routed through the GNX3000’s effects
processing for both recording an performance.
USB 1-2 LVL
A gain/attenuation control to optimize the level of sources being recorded up the
USB 1-2 channels.
USB 3-4 LVL
A gain/attenuation control to optimize the level of sources being recorded up the
USB 3-4 channels.
USB PLAY MIX
Controls the level balance between the GNX3000’s processing and the USB
stream played back from your computer.
Computer Recording with a Mac
Out of the box, the GNX3000 is core audio and core MIDI compatible. No drivers
need to be installed. Just plug in the USB cable.
An installer is provided for X-Edit, the Editor/Librarian application. Just insert the
disc and follow the on-screen prompts.
If you’re using a Mac, use the GNX3000 in ASIO/MAC USB mode (this is the default
USB mode from the factory). To verify Audio MIDI connection, use Apple’s Audio
MIDI Setup application found in the Applications/Utilities folder.
If properly connected, “GNX3000” should appear in the Input/Output Audio Device
list and the MIDI Devices tab, an icon labeled “GNX3K” should be present. Refer to
Audio MIDI Setup help files for additional information on their use.
GNX3000 Owner’s Manual
111
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
