Utilities
The Utility section contains all of the menus for assigning global functions to the
GNX3000. Global functions affect the GNX3000 in its entirety rather than on a per
preset basis. The Utility menus include: Volume Pedal Update, Expression Pedal
Calibration, Bounce-Back, Bank Naming, MIDI Channel, MIDI Sysex Dumps, Amp
Dumps, MIDI Mapping, MIDI Merge, and Factory Reset. To enter the Utility section,
press the
UTILITY button. Once in the Utility menu, the NEXT button selects the next
menu (scrolls to the right), and the
PREV button selects the previous menu (scrolls
to the left). Each of these Utility menus is described in more detail in the following
pages.
Volume Pedal Update
The GNX3000 lets you select the EXPRESSION PEDAL’s position to be updated, after
changing presets, when it is linked to the Volume Parameter. This feature lets you
change presets and keep the volume level from the previous preset, if the EXPRESSION
PEDAL controls the volume for both presets. If this feature is disabled, new presets are
set to the volume level value stored with the preset. The procedure for enabling or
disabling the Volume Pedal Update is as follows:
1. Press the
UTILITY button. The button will light indicating you are in the Utility
menu.
2. Use the
PREV or NEXT buttons to select volumpdl (Volume Pedal Update) is
displayed.
3. Rotate the DATA WHEEL to select
On (enabled), or OF (disabled).
4. When finished, press EXIT
.
Preset Bounceback
If you would rather not bypass individual presets in Preset Mode by pressing their
FOOTSWITCHES repeatedly, you can enable the Preset Bounceback function in the
Utility menu. For example, let’s say you select Preset 1 using FOOTSWITCH 1 as your
rhythm tone. Then you select Preset 4 using FOOTSWITCH 4 as your solo tone. You
can now press FOOTSWITCH 4 again and Preset 1 will be selected again. Pressing
FOOTSWITCH 4 repeatedly will bounceback between Preset 4 and Preset 1. To enable
the Preset Bounceback feature, do the following:
1. Press the
UTILITY control panel button and use the PREV/NEXT arrow buttons to
locate the Bounceback feature. The display will read
BOUNCBAK.
2. Rotate the DATA WHEEL to turn the BounceBack feature on.
3. When finished, press EXIT
.
NOTE: The Preset Bounceback feature only works when the GNX3000 is in Preset
Mode.
For more information regarding the footswitch functions for Preset Mode see page 94.
118
Utilities
GNX3000 Owner’s Manual
To Next Page
Need help?
General
