synthtlk Attack Release Vox Senstvty mod bal*
Envelope Senstvty Range MOD Bal MOD MIX
DETUNe Amount MOD Bal Mod levl
pitch SHIFT MOD Bal Mod levl
dlyonoff (Delay On/Off) Turns the Delay module on and off
DLY fdbk (Delay Feedback) Controls the amount of Delay Feedback
threshld (Delay Threshold) Controls the Ducker Threshold for the Delay
duckattn (Ducker Attenuation) Controls the attenuation level applied to the Delay signal when
the Ducker Threshold is exceeded
Dly levl (Delay Level) Controls the Mix Level of the selected Delay Type
DLY BAL (Delay Balance) Controls the left/right balance of the selected Delay Type
**DLY sprd (Delay Spread) Controls the left/right balance of the selected Delay Type
rvbonoff (Reverb On/Off) Turns the Reverb effect on and off
RVB PRE (Reverb Predelay) Controls the Reverbs Predelay time
rvbdecay (Reverb Decay) Controls the Reverbs Decay time
RVB levl (Reverb Level) Controls the Reverbs Mix Level
RVB BAL (Reverb Balance) Controls the left/right balance of the selected Reverb Type
VOL PRE (Volume Pre) Controls the Volume after the Amp Modeling, but before the Effects
VOL PoST (Volume Post) Controls the Volume at the end of the Effects chain
LFo1 SPD (LFO 1 Speed) Controls the modulation speed of Expression LFO 1
LFo2 SPD (LFO 2 Speed) Controls the modulation speed of Expression LFO 2
80
GNX3000 Owner’s Manual
Expression Pedal Assignment
* This Parameter is only available using the X-Edit
TM
Editor/Librarian software.
**Delay Balance is replaced by Delay Spread when Spread Delay is selected.
To Next Page
Loading...
Need help?
General
