C-4
Battery Pack Replacement
Battery Pack Replacement
Introduction
The HDPQ Xplorer contains an easily replaceable internal battery pack. See Appendix
D for ordering information.
WARNING
Replace with Dranetz NiMH battery pack BD-HDPQ (118348-G1) only.
ADVERTENCIA
Reemplace con batería Dranetz NiMH BD-HDPQ (118348-G1) solamente.
AVERTISSEMENT
Remplacer par la batterie Dranetz NiMH BD-HDPQ (118348-G1) exclusivement.
WARNUNG
Nur mit Dranetz NiMH BD-HDPQ (118348-G1) Batteriesatz auswechseln.
NOTE
During normal operation, the battery pack will be slightly warm to the touch.
Procedure
Follow these steps to replace the battery pack.
Step Action
1 Switch the HDPQ Xplorer power button to off.
2 Turn off power to the circuit being measured.
3 Disconnect voltage and current probes from the circuit and the HDPQ
Xplorer’s rear panel.
4 On the bottom of the HDPQ Xplorer, push the tab to release the battery
cover. Refer to the diagram shown on page C-5.
5 Remove the cover.
6 Pull up on removal strap and remove battery pack.
7 Insert the new pack into the compartment making sure to observe
polarity markings.
8 Replace the cover and press down until it latches closed.
9 Discard the old battery pack in accordance with Environmental
Protection Agency (EPA) regulations.
10 Switch the HDPQ Xplorer power button to on.
Shop for Power Metering products online at:
1.877.766.5412
www.PowerMeterStore.com
To Next Page
Loading...
Need help?
General
