E-7
APPENDIX E/ Common Circuit Connections
Interconnect Jumpers
Interconnect
jumpers
The standard cable set for the HDPQ includes four (4) interconnect jumpers bearing
part number 114013-G1. These interconnect jumpers can be used to connect the same
conductor points together and are rated 600V CAT III. When using the interconnect
jumpers, also use the supplied wire markers to identify the wiring connections
applicable to your installation.
Refer to Appendix A Optional Accessories for more information on the list of available
wire markers.
WARNINGS
DO NOT EXCEED 600 VRMS when using Dranetz P/N 114013-G1 interconnect
jumpers.
For circuit configurations above 600VRMS each voltage channel input is to be
individually connected to the HDPQ instrument with the supplied 1000V CAT III
cables and safety clips ONLY.
Shop for Power Metering products online at:
1.877.766.5412
www.PowerMeterStore.com
To Next Page
Loading...
Need help?
General
