Programming
Operating Instructions 581 - 01.0 - 05/2016 107
4. Press the button.
The following options are available:
• S
tep by step
• S
tart ref.
• S
t.cont.operat
• L
ooper adjust.
Step by step
In the subitem Ste
p by step sewing is stopped at various points
during the sewing process. The stop points make it easier to check
and set the machine.
To start the test program:
1. Press the button.
The set value has the following meaning:
•0 = Normal sewing process, the test
program is switched off.
•1 = After switching the valves for the needle thread
ca
tcher, the sewing process is stopped.
• 2 = After switching the valves for the relevant thread cutting
system,
the sewing process is stopped.
• 3 = After switching each valve, the sewing process is
stop
ped.
You can quit the test program by pressing and then .
To Next Page
