DURKOPP ADLER 581 - Page 165

Troubleshooting
Operating Instructions 581 - 01.0 - 05/2016 163
1006 Sewing motor fault • Max. speed exceeded
• Sewing motor cable
de
fective
• Sewing motor defective
• Switch the machine off and
o
n again
• Replace the encoder
• Perform reset
• Replace the sewing motor
• Contact customer service
1007 Error in the reference
ru
n
• Replace the encoder
• Eliminate stiff movement in
th
e machine
1008 Sewing motor encoder
er
ror
• Replace the encoder
1010 Sewing motor
syn
chronization error
• External synchronizer plug
(Sub-D, 9-pin) not
connected
• Connect plug of external
synchronizer to control, use
correct connection (Sync)
• Replace the reference
switch or
synchronizer
• Only required for machines
with transmission!
1011 Sewing motor
syn
chronization error
(Z pulse)
• Switch off the control, use
handwheel to turn and
switch on the control again
• If error is not corrected,
check encoder
1012 Sewing motor
syn
chronization error
• Replace the synchronizer
1051 Sewing motor timeout • Cable to sewing motor
reference switch defective
• Reference switch defective
• Replace the cable
• Replace reference switch
(9
815 935006)
1052 Sewing motor
over
current
• Sewing motor cable
defective
• Sewing motor defective
• Control defective
• Replace the sewing motor
cable
• Replace the sewing motor
• Replace the control
Error Meaning Possible cause Remedial action