SHANGHAI ESURVEY GNSS CO., LTD.
34
5. To add another point, do the following:
a. Press F2 AddPt.
b. Do one of the following, and press F3 ENT for confirmation:
To find a known point, press F1 FIND / F2 LIST.
To directly input ID of the target point and the height of the reflector or
press ↓ → F1 ENH.
c. Press F3 ALL to trigger angle and distance measurements.
6. Press F4 ENT for confirmation.
If you need to start measurement again, press F1 PREV.
7. Optional: To add more points, repeat step 1 ~ 6.
8. Press F1 COMPUTE. The result is as follows:
9. Press F4 ENT for confirmation. The display shows Data Saved and Station Settled.
5.2.4 COGO
To set COGO, do the following:
1. To enter Program menu page, press MENU and F1 PROG / 1.
2. Press F4 or 4:
o : it indicates that settings are done.
o : it indicates that settings are not done.
To Next Page
Loading...