SHANGHAI ESURVEY GNSS CO., LTD.
35
3. Do the following:
a. Set a Job
If you have done it before, you can skip it.
b. Set the Station
If you have done it before, you can skip it.
c. Set the Orientation
If you have done it before, you can skip it.
d. Start COGO
5.2.4.1 Set a Job
See 5.2.1.1 Set a Job for details.
5.2.4.2 Set the Station
See 5.2.1.2 Set the Station for details.
5.2.4.3 Set the Orientation
See 5.2.1.3 Set the Orientation for details.
5.2.4.4 Start COGO
To start COGO, do the following:
1. In COGO display, press F4 / 4:
2. Do the following:
a. Set Inverse or Traverse Computation
b. Set Intersections
c. Set Offset
d. Set Extension
5.2.4.4.1 Set Inverse or Traverse Computation
To set inverse or traverse computation, do one of the following:
Set Inverse Computation
Set Traverse Computation
To Next Page
Loading...
Need help?
General