e-survey E3L - Page 6

SHANGHAI ESURVEY GNSS CO., LTD.
II
4.7 Free-Coding ............................................................................................................ 19
4.8 Laser Pointer .......................................................................................................... 20
4.9 Check Tie ................................................................................................................ 20
4.10 Main Settings ........................................................................................................ 21
4.11 Tracking ................................................................................................................ 21
4.12 Light On/Off .......................................................................................................... 21
4.13 Units ...................................................................................................................... 21
5 Menu Key ................................................................................................. 22
5.1 Overview ................................................................................................................. 22
5.2 Program Menu ........................................................................................................ 23
5.2.1 Surveying ........................................................................................................... 24
5.2.1.1 Set a Job ..................................................................................................... 24
5.2.1.2 Set the Station ............................................................................................. 25
5.2.1.3 Set the Orientation ...................................................................................... 25
5.2.1.4 Start Survey ................................................................................................ 26
5.2.2 Stake out ........................................................................................................... 27
5.2.2.1 Set a Job ..................................................................................................... 27
5.2.2.2 Set the Station ............................................................................................. 27
5.2.2.3 Set the Orientation ...................................................................................... 27
5.2.2.4 Start Staking out .......................................................................................... 28
5.2.3 Free Station ....................................................................................................... 31
5.2.3.1 Set a Job ..................................................................................................... 32
5.2.3.2 Set Accuracy Limit ...................................................................................... 32
5.2.3.3 Start Free Station ........................................................................................ 33
5.2.4 COGO ................................................................................................................ 34
5.2.4.1 Set a Job ..................................................................................................... 35
5.2.4.2 Set the Station ............................................................................................. 35
5.2.4.3 Set the Orientation ...................................................................................... 35
5.2.4.4 Start COGO ................................................................................................. 35
5.2.4.4.1 Set Inverse or Traverse Computation ................................................... 35
5.2.4.4.1.1 Set Inverse Computation ................................................................ 36
5.2.4.4.1.2 Set Traverse Computation ............................................................. 37
5.2.4.4.2 Set Intersections ................................................................................... 38
5.2.4.4.2.1 Set Bearing-bearing ....................................................................... 38
5.2.4.4.2.2 Set Bearing-distance ...................................................................... 39
5.2.4.4.2.3 Set Distance-distance .................................................................... 40
5.2.4.4.2.4 Set Four Points .............................................................................. 41
5.2.4.4.3 Set Offset .............................................................................................. 42
5.2.4.4.3.1 Set Distance-offset ......................................................................... 42
5.2.4.4.3.2 Set Point by .................................................................................... 43
5.2.4.4.4 Set Extension ....................................................................................... 44
5.2.5 Tie Distance ....................................................................................................... 45
5.2.5.1 Set a Job ..................................................................................................... 46
5.2.5.2 Set the Station ............................................................................................. 46
5.2.5.3 Set the Orientation ...................................................................................... 46