ECKELMANN E-Control CNC - Page 93

93 / 97
Introduction Manual ENC66
eckelmann.de
List of figures
ENC66 13
7-Segment indicator 18
Example of a structure with the ENC66 controller 22
Wiring of an ENC66 controller 23
Connection controller <--> PC 24
Connecting cable controller <--> PC 24
Naming the connection 26
Select the correct interface 27
Dialog box with connection parameters 27
Terminal window 28
Controller messages after boot up 28
Prompt of monitor interface 29
Naming a connection 30
Configuring a telnet connection 30
Login prompt via telnet 31
monitor interface via telnet 31
Activated monitor interface 34
Changing the IP address 35
NetConf displaying controllers in the network 36
Modifying an IP address with NetConf 36
Modify Gateway and Subnet Mask in NetConf 37
Add a new controller to the list in Netconf, empty 38
Dialog in Netconf with entered MAC and IP address 38
Boot monitor of the ENC66 in the terminal program 39
Displaying the version of the bootloader 40
Displaying the version of the boot loader and the CNC firmware 40
Accessing the file transfer function in the terminal program 41
Selecting the zmodem protocol 41
Transferring the firmware to the controller 41
Transfer of the CNC firmware finished 42
Removing the firmware from a ENC66 controller 42
Representation of a G function 55
Start dialog stdHMI 58
Checking the drives in stdHMI 59
Manual travel in StdHMI 60
Programming in stdHMI 61
DIN example program in the StdHMI program editor 63
StdHMI in the Automatic mode 65
Loaded program in textual and graphical view 66
Program with M-functions shown in the StdHMI 67
Changing the colour setting of the graphical display 69
Controller setup for the example 71
Select the target settings in E-Tools PLC/2 72
Naming the first block 72
The empty program block 73
PLC configuration 74
Opening the PLC configuration 75
Adding a LBM module 75
The added LBM DOM16 module in the PLC configuration 76
Byte addresses changed to word addresses 76
The added LBM DIM16 module 77