Ecotech Acoem Serinus 30 - Page 214

Serinus® 30 User Manual 3.3
Page 214
175
AO2 Over-Ranging
1 = Over Ranging Enabled
2 = Over Ranging enabled and currently active
176
AO3 Over-Ranging
177
Heater Set Point
Cell Heater Set Point units in °C
178
High Volt Adjust Pot
High voltage pot setting
179
PMT Test LED Pot
PMT Test LED intensity controller POT
180
Last Power Failure
Time Stamp of the Last power fail (4 byte time stamp)
Bit 31:26 ---- Year (0 – 99)
Bit 25:22 ---- Month ( 1 – 12)
Bit 21:17 ---- Date (1 – 31)
Bit 16:12 ---- Hour (00 – 23)
Bit 11:06 ---- Min (00 – 59)
Bit 05:00 ---- Sec (00 – 59)
181
Inst Manifold Press.
Manifold Pressure in S40 instruments (instantaneous)
182
Cell Press. (Gas 5)
Cell Pressure for Gas 5 (Nx)
183
Gas 4 Inst.
Calculated gas concentration currently displayed on front
screen E.g. NH3
184
Gas 4 Avg.
Average of the readings (for Gas 4) of the last n minutes where
n is the averaging period E.g. NH3
185
Gas 5 Inst.
Calculated gas concentration currently displayed on front
screen E.g. Nx
186
NH3 Conv. Efficiency
187
Cell/Lamp Duty Cycle
188
Mirror T. Duty Cycle
189
Flow Temp Duty Cycle
190
Cooler T. Duty Cycle
191
Conv Temp Duty Cycle
192
CO Conv T Duty Cycle
193
F/Scale Curr AO 0
20 mA Calibration value
194
F/Scale Curr AO 1
195
F/Scale Curr AO 2
196
Z Adj Curr AO 0
4 mA Calibration value
197
Z Adj Curr AO 1
198
Z Adj Curr AO 2
199
Ext Analog Input 0
The value of the external analog input after the multiplier and
offset have been applied
200
Ext Analog Input 1
201
Ext Analog Input 2
202
Conv Set Point
Converter Set Point
203
Cal. Pressure 3
Calibration Pressure 3