C
HAPTER
38
| Multicast Filtering Commands
MVR for IPv6
– 1274 –
mvr6
source-port-mode
dynamic
This command configures the switch to only forward multicast streams
which the source port has dynamcially joined. Use the no form to restore
the default setting.
SYNTAX
[no] mvr6 source-port-mode dynamic
DEFAULT SETTING
Forwards all multicast streams which have been specified in a profile and
bound to a domain.
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† By default, the switch forwards any multicast streams within the
address range set by a profile, and bound to a domain. The multicast
streams are sent to all source ports on the switch and to all receiver
ports that have elected to receive data on that multicast address.
â—† When the mvr6 source-port-mode dynamic command is used, the
switch only forwards multicast streams which the source port has
dynamically joined. In other words, both the receiver port and source
port must subscribe to a multicast group before a multicast stream is
forwarded to any attached client. Note that the requested streams are
still restricted to the address range which has been specified in a profile
and bound to a domain.
EXAMPLE
Console(config)#mvr6 source-port-mode dynamic
Console(config)#
mvr6
upstream-source-ip
This command configures the source IPv6 address assigned to all MVR
control packets sent upstream on the specified domain. Use the no form to
restore the default setting.
SYNTAX
mvr6 domain domain-id upstream-source-ip source-ip-address
no mvr6 domain domain-id upstream-source-ip
domain-id - An independent multicast domain. (Range: 1-5)
source-ip-address – The source IPv6 address assigned to all MVR
control packets sent upstream. This parameter must be a full IPv6
address including the network prefix and host address bits.
DEFAULT SETTING
All MVR reports sent upstream use a null source IP address
To Next Page
Loading...
Need help?
General
