C
HAPTER
38
| Multicast Filtering Commands
MVR for IPv6
– 1273 –
◆ When MVR proxy switching is disabled:
■
Any membership reports received from receiver/source ports are
forwarded to all source ports.
■
When a source port receives a query message, it will be forwarded
to all downstream receiver ports.
■
When a receiver port receives a query message, it will be dropped.
EXAMPLE
The following example enable MVR6 proxy switching.
Console(config)#mvr6 proxy-switching
Console(config)#
RELATED COMMANDS
mvr6 robustness-value (1273)
mvr6
robustness-value
This command configures the expected packet loss, and thereby the
number of times to generate report and group-specific queries. Use the no
form to restore the default setting.
SYNTAX
mvr6 robustness-value value
no mvr6 robustness-value
value - The robustness used for all interfaces. (Range: 1-10)
DEFAULT SETTING
2
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ This command sets the number of times report messages are sent
upstream when changes are learned about downstream groups, and
the number of times group-specific queries are sent to downstream
receiver ports.
◆ This command only takes effect when MVR6 proxy switching is enabled.
EXAMPLE
Console(config)#mvr6 robustness-value 5
Console(config)#
RELATED COMMANDS
mvr6 proxy-switching (1272)
To Next Page
Loading...
