M588-08-880 Issue D
Page 100 © Edwards Limited 2017. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Digital pressure measurements
4. Using a suitable screwdriver, remove both side panels and store them safely nearby.
5. Refer to Figure 70 and photo A to identify the external position of the pressure transducer the pump.
6. Slid the cable anchor mount into position over the edge of the hole in the top panel for the pump inlet. Refer to
Figure 75.
7. Connect the cable to the pressure transducer pass the cable through the top panel and secure to the cable
anchor mount with a cable tie. Refer to Figure 74.
Figure 74 - External position of pressure transducer
Figure 75 - Cable anchor in position on top panel
To Next Page
Loading...
